Goodman Error Code 2: Pressure Switch Stuck Closed

LED Blink Pattern

How to Fix Goodman Code 2

1. Step 1: Turn off power to your HVAC unit at the circuit breaker for 30 seconds, then turn it back on. This may reset the switch.
2. Step 2: If the issue persists, check the pressure switch for any visible signs of damage or dirt. If it's clean and undamaged, it's time to call a professional.
3. Step 3: Do not attempt to open the unit or handle the refrigerant lines yourself. This can be dangerous and should be left to a qualified technician.

How to Reset Goodman Code 2

1. Turn off the furnace power switch, usually located on or near the unit.
2. Turn off the circuit breaker for the furnace. Wait 30 seconds.
3. Restore power at the breaker and flip the furnace switch back on.
4. Set the thermostat to call for heat. If the error code returns after 2-3 ignition attempts, the fault requires repair.

Resetting clears the code from the display but does not fix the underlying fault. If the code returns after reset, proceed to the diagnostic steps above.

What Does Goodman Error Code 2 Mean?

Error code 2 on your Goodman HVAC unit indicates that the pressure switch is stuck in the closed position. This switch is designed to monitor the refrigerant pressure in your system and ensure it's within safe limits. When it gets stuck closed, it falsely signals that the pressure is too high, causing your system to shut down. This is a common issue with Goodman units and can usually be resolved by cycling the power or checking the switch itself.

Common Causes

• Wiring issue causing the switch to stick
• Dirt or debris preventing the switch from opening
• Faulty pressure switch
• Incorrect refrigerant charge causing high pressure

Diagnostic Steps

Recall Notices

Replacement Parts

Related Codes on Same Models

Other codes that affect the same Goodman model families as 2.