Goodman Error Code STEADY-ON: Normal Operation
Warning: No immediate action needed. Your Goodman HVAC system is running continuously, likely due to a thermostat or system setting.
How to Fix Goodman Code STEADY-ON
- Check your thermostat settings and ensure the fan is set to 'AUTO'
- Replace your air filter if it's dirty
- If the issue persists, try turning off your HVAC system at the circuit breaker for 30 seconds, then turn it back on
How to Reset Goodman Code STEADY-ON
- Turn off the furnace power switch, usually located on or near the unit.
- Turn off the circuit breaker for the furnace. Wait 30 seconds.
- Restore power at the breaker and flip the furnace switch back on.
- Set the thermostat to call for heat. If the error code returns after 2-3 ignition attempts, the fault requires repair.
What does STEADY-ON mean?
The STEADY-ON error code on your Goodman HVAC system indicates that the unit has been running continuously for an extended period. This is not a critical error, but it's important to address to prevent excessive energy usage and potential system damage. The most common causes for this code are incorrect thermostat settings or a system issue that's preventing the unit from cycling off.
Affected Models
Recall Notices
Goodman/Daikin Evaporator Coil Drain Pans Recalled Due to Fire Hazard
22-014
Drain pans can overheat, melt, and deform, posing a fire hazard. Recall expanded January 2024.
Replacement Parts
| Part | OEM Number | Est. Cost |
|---|---|---|
| Thermostat | — | — |
| Control Board | C1200-1200 | — |
Related Codes on Same Models
| Code | Description | Severity |
|---|---|---|
| 1 | System Lockout | Warning |
| 2 | Pressure Switch Stuck Closed | Warning |
| 3 | Pressure Switch Stuck Open | Warning |
| 4 | Open High Limit Switch | Warning |
| 5 | Flame Sensed With Gas Valve Off | Warning |
| 6 | Open Rollout Switch | Warning |
| 7 | Low Flame Signal | Warning |
| 8 | Ignitor Error | Warning |
| CONTINUOUS | Reversed Polarity | Warning |
| F01 | Goodman Code F01 - Ignition Lockout | Critical |